Share Share this post on Digg Del. Please note that you must turn your cutter off and on for the change to take effect. Dec 7, 6: If you are unsure if your cable is a RS C cable, contact your plotter distributor. Can you make anything work, as in setup, test, etc with the communication cable disconnected.
|Date Added:||23 September 2017|
|File Size:||36.89 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
How much is it worth? December 6th, Dec 6, 5: Reply With Quote Quick reply to this message. Please enter a valid email address for yourself. Type Your Message Below: If this has been in storage for 5 of more years can the firmware become corrupt? Should the lights be on from right control panel be lit all the time or only when you press the required buttom, in any case nothing happens when pressing any on the buttons.
If you wish to cut in a portrait fashion simply rotate your graphics.
Technical Support for CAMM-1 CM 24″ Vinyl Cutter
Dec 6, In order to be able to post messages on the T-Shirt Forums, you must first register. Dec 5, 7: I am away for a few days, will dig deeper on my return, thank Kai.
If you are unsure if your cable is a RS C cable, contact your rolahd distributor. Any help please would be great.
Dec 7, 6: I have been offered a used Roland Camm-1 CM in good condition, but don’t know if it is a rip off or a steal xm24 a deal. You won’t be able to post until your email address has been confirmed.
In the Win XP printer page is shows the driver is installed. Set Width to mm inches and Height to mm 23 inches.
Then press setup and the machine will perform a test. October 29th, Have you seen it cut?
No registered users c,24 0 guests. Ensure that you are using a Landscape page. SignTools 4 cuts from the bottom left of the page either manually place object s in the bottom left of the CorelDRAW page or use the “Vinyl Saver” tool with the sliding bar all rolnad way to the left. When I power up cutter the power light shows steady and the internal fan is running.
If your using a sign making software you would have to use the original cable ie. Roland Camm 1 CM value. Can you make anything work, as in setup, test, etc with the communication cable disconnected. Need Help with Roland Camm Self Promoting on the Boards. All of the 10 DIP switches are down. December 7th, Dec 7, 6: Need to Upload an Image?
C24 is online Users browsing this forum: Share Share this post on Digg Del.